Ditch the Grids, Slay the Wig Game with Not Your Knots Eraser!

This video is a tutorial about how to use a Not Your Average Grid Eraser to hide the grids and knots on a frontal wig without bleaching the knots.

Here are the steps on how to use Not Your Average Grid Eraser according to the video:

• Do not wind up the tube before warming it up because you could damage it.
• It is recommended to wear a wig cap over your hair.
• Place the tube top side up into hot water for two and a half to three minutes. You can also blow dry it to warm it up.
• Only wind it up about one millimeter and do not over warm the product because it can make it too soft and seep too much into the hair.
• Gently press and stroke forwards or backwards until you reach your desired coverage.
• If it becomes dry during your application, just reheat it with a blow dryer.
• After applying the Not Your Average Grid Eraser, use a little bit of foil and a towel to remove the excess that gets on the hair.
• You can use foundation powder to darken the area if needed.
• The video recommends using Got2b Glued Holding Spray to hold the lace down.